注意：要運行上述ACCESS例程請先下載數據庫，放在db 或 rwdata文件夾下。請將例程放在根目錄下。
<%
Dim mode
mode=request.form("text4")
if mode=1 then
name=request.form("text1")
age=request.form("text2")
addr=request.form("text3")
if not isnumeric(age) then response.write "age must be number!try again":response.end
age=clng(age)
end if '********************************************************************
' 與AccessDB相關的連接信息
' 可以參照它建立您的數據庫連接
'********************************************************************
Dim conn,rs,dbpath
Set conn=Server.CreateObject("ADODB.Connection")
Set rs=Server.CreateObject("ADODB.RecordSet")
dbpath=Server.MapPath("rwdata/db_test_com.mdb")
conn.Open "Driver={Microsoft Access Driver (*.mdb)}; DBQ="&dbpath
'********************************************************************
'******************************************************************** dim strsql
'********************************************************************
' 讀數據庫相關操作
sub readdb()
strsql="select * from test"
rs.open strsql,conn,1,1
if rs.EOF then response.write "no record at all":exit sub
response.write ""
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""&rs.Fields(i).Name&" | "
next
response.write " "
while not rs.EOF
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""&rs.Fields(i).Value&" | "
next
response.write " "
rs.MoveNext
wend
response.write " "
rs.Close
end sub
'********************************************************************
'********************************************************************
' 寫數據庫相關
sub insertdata()
strsql="INSERT INTO test(name,age,addr) VALUES('"&name&"',"&age&",'"&addr&"')"
rs.Open strsql,conn,1,3
end sub
'********************************************************************
if mode=1 then
call insertdata()
response.write "insert ok!"
elseif mode=2 then
call readdb()
end if '********************************************************************
' 釋放數據庫連接對象
set rs=nothing
set conn=nothing
%>
|
